Features

Valspar Interior Wall Epoxy is specially designed for interior applications requiring maximum durability and adhesion. When fully cured, the semi-gloss finish is highly scrubable, scuff resistant and moisture resistant. This is a 2-Component System - Mix "Part-A" with "Part-B" per instructions before using!

Coverage

One gallon covers 350-450 sq. ft. per gallon on smooth surfaces, 250-350 sq. ft on rough surfaces. Thinning is not recommended unless needed for spray application.

Where to Use

Properly prepared interior surfaces including drywall, concrete, wood, brick and metal. Use it for walls in the garage, kitchen, bathroom, laundry room, utility room or wherever maximum durability is a must.

Preparing the Surface

Previously Painted: Clean the surface thoroughly using a solution of TSP and water. Follow by rinsing with clean water. The surface must be free of dirt, grease and stains. Glossy surfaces should be dulled by sanding or by using a liquid deglosser. Scrape off any loose paint and smooth edges by sanding. Drywall: Smooth tape joints and wipe all powdery dust from the surface. Prime bare areas with Valspar® Drywall Primer. Concrete/Masonry: Concrete surfaces should be cured for a minimum of 60 days. Remove any powdery dust or efflorescence from mortar joints. Metal: Remove any rust or oil from the surface. Prime metal with a rust-inhibitive metal primer. Wood: Sand new wood surfaces smooth and prime with Valspar® Multi-Purpose Primer.

Dry Time

Dries to the touch in 1 hour. Recoat in 4-6 hours. Allow fresh paint to cure 7 days before washing.

Lead Warning

WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN DAMAGE ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.